Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1994G 20 VAN V6-262 4.3L VIN ZREPAIR AND DIAGNOSISCRUISE CONTROLCRUISE CONTROL MODULEDIAGRAMSDIAGNOSTIC AIDSWIRE REPAIR PROCEDURESMETRI-PACK CONNECTORGENERAL
1994 Chevrolet G 20 Van V6-262 4.3L VIN Z
General
1994 Chevrolet G 20 Van V6-262 4.3L VIN ZSECTION General
Metri-pack Connector:
Contact Tang And Amount Of Deformation:
The Metri-Pack connectors use a pull-to-seat type terminal. The special tool required to remove the terminal is J 35689-A terminal remover. If removal is attempted with an ordinary pick, there is a good chance that the terminal will be bent or deformed.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.