Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1994C 2500 SUBURBAN 2WD V8-350 5.7LREPAIR AND DIAGNOSISCRUISE CONTROLCRUISE CONTROL SWITCHSERVICE AND REPAIR
1994 Chevrolet C 2500 Suburban 2WD V8-350 5.7L
Cruise Control Switch: Service and Repair
1994 Chevrolet C 2500 Suburban 2WD V8-350 5.7LSECTION Service and Repair
1. Disconnect battery ground cable.
2. Remove cruise control switch protector cover, Fig. 38.
3. Disconnect switch electrical connector, then remove the switch and cruise control wire.
4. Reverse procedure to install.
Fig. 38 Cruise Control Switch Replacement.:
2. Remove cruise control switch protector cover, Fig. 38.
3. Disconnect switch electrical connector, then remove the switch and cruise control wire.
4. Reverse procedure to install.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.