Coolant Temperature Sensor/Switch (For Computer): Specifications

1993 Chevrolet S10/T10 P/U 2WD V6-173 2.8LSECTION Specifications
ENGINE COOLANT TEMPERATURE (ECT) SENSOR


212°F or (100°C) 177 Ohms

158°F or (70°C) 467 Ohms

100°F or (38°C) 1800 Ohms

68°F or (20°C) 3520 Ohms

40°F or (4°C) 7500 Ohms

20°F or (-7°C) 13,500 Ohms

0°F or (-18°C) 25,000 Ohms

-40°F or (-40°C) 100,700 Ohms




IDLE AIR CONTROL (IAC) VALVE


Terminals "A" to "B" 40 to 80 Ohms

Terminals "C" to "D" 40 to 80 Ohms

Terminals "B" to "C" Infinite Ohms

Terminals "A" to "D" Infinite Ohms



MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR


1,000 to 2,000 Feet 3.6 to 5.2 Volts

2,000 to 3,000 Feet 3.5 to 5.1 Volts

3,000 to 4,000 Feet 3.3 to 5.0 Volts

4,000 to 5,000 Feet 3.2 to 4.8 Volts

5,000 to 6,000 Feet 3.0 to 4.6 Volts

6,000 to 7,000 Feet 2.9 to 4.5 Volts

7,000 to 8,000 Feet 2.8 to 4.3 Volts

8,000 to 9,000 Feet 2.6 to 4.2 Volts

9,000 to 10,000 Feet 2.5 to 4.0 Volts



OXYGEN (O2S) SENSOR

Closed Loop 100 mV (.1 volt) to .999 mV (1.0 volt)



THROTTLE POSITION SENSOR

Idle (normal) .45 to .95 volts.
(maximum) 1.25 volts.
Wide Open Throttle 4.0 to 4.5 volts.

The Throttle position Sensor is not adjustable on this engine but should read below 1.25 volts at closed throttle and about 4.5 volts at wide open throttle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.