Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1993S10/T10 P/U 2WD V6-173 2.8LREPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYKEYLESS ENTRY TRANSMITTERSERVICE AND REPAIR
1993 Chevrolet S10/T10 P/U 2WD V6-173 2.8L
Keyless Entry Transmitter: Service and Repair
1993 Chevrolet S10/T10 P/U 2WD V6-173 2.8LSECTION Service and Repair
1. Ground pin G of the Data Link Connector (DLC).
2. Press any button of the first transmitter to be programmed.
3. The receiver module will respond by locking/unlocking doors and activating rear window release.
4. Press any button of the second transmitter to be programmed (if used).
5. The receiver module will respond by locking/unlocking doors and activating the rear window release.
6. Remove the ground applied to pin G of the Data Link Connector (DLC).
7. Transmitter operation is verified by locking and unlocking the doors and activating the rear window release.
2. Press any button of the first transmitter to be programmed.
3. The receiver module will respond by locking/unlocking doors and activating rear window release.
4. Press any button of the second transmitter to be programmed (if used).
5. The receiver module will respond by locking/unlocking doors and activating the rear window release.
6. Remove the ground applied to pin G of the Data Link Connector (DLC).
7. Transmitter operation is verified by locking and unlocking the doors and activating the rear window release.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.