Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1993LUMINA APV V6-3800 3.8LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTIGNITION SYSTEMCAMSHAFT POSITION SENSORSERVICE AND REPAIR
1993 Chevrolet Lumina APV V6-3800 3.8L
Camshaft Position Sensor: Service and Repair
1993 Chevrolet Lumina APV V6-3800 3.8LSECTION Service and Repair
Cam And Crankshaft Sensors:
REMOVE OR DISCONNECT
- Disconnect battery ground cable.
- Remove water pump pulley attaching bolts, then the serpentine belt and water pump pulley.
- Disconnect sensor wiring connector and remove sensor retaining bolt.
- Twist and pull sensor to remove.
INSTALL OR CONNECT
- Install new sensor, lubricate sensor O-ring.
- Sensor retaining bolt.
- Reconnect sensor wiring connector and remove sensor retaining bolt.
- Install the serpentine belt and water pump pulley.
- Reconnect battery ground cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.