Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1993CAPRICE WAGON RWD V8-350 5.7LREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - BRAKES AND TRACTION CONTROLELECTRONIC BRAKE CONTROL MODULESERVICE AND REPAIR
1993 Chevrolet Caprice Wagon RWD V8-350 5.7L
Electronic Brake Control Module: Service and Repair
1993 Chevrolet Caprice Wagon RWD V8-350 5.7LSECTION Service and Repair
1. Disconnect battery ground cable.
2. On wagon models, remove rear quarter trim panel as follows:
a. Pull top edge of lefthand side rear quarter trim panel from groove in quarter window garnish molding.
b. Pull tabs on quarter trim panel from slots in back body pillar and lock pillar trim panel.
c. Remove bottom edge of quarter trim panel from glove on load floor, then remove panel.
3. On all models, disconnect EBCM electrical connector.
4. Remove two EBCM to bracket attaching nuts, then the EBCM from the vehicle.
5. Reverse procedure to install, perform ABS system check as described under DIAGNOSIS AND TESTING PROCEDURE.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.