Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1993CAPRICE WAGON RWD V6-262 4.3LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSSPECIFICATIONSMECHANICAL SPECIFICATIONS
1993 Chevrolet Caprice Wagon RWD V6-262 4.3L
Mechanical Specifications
1993 Chevrolet Caprice Wagon RWD V6-262 4.3LSECTION Mechanical Specifications
TIGHTENING SPECIFICATIONS
Fuel lines to TBI body 22 lb.ft.
Fuel meter cover attaching screws 27 lb.in.
Fuel meter body attaching screw 35 lb.in.
Fuel inlet nuts to throttle body 30 lb.ft.
Fuel outlet nuts to throttle body 21 lb.ft.
Front fuel tank retaining strap bolts 26 lb.ft.
Rear fuel tank retaining strap bolts 8 lb.ft.
Idle Air Control Valve (IAC) 13 lb.ft.
TBI attaching bolts 16 lb.ft.
TPS attaching screws 18 lb.in.
Rear fuel tank retaining strap bolts 8 lb.ft.
Fuel level sender attaching nuts 27 lb.in.
Fuel lines to TBI body 22 lb.ft.
Fuel meter cover attaching screws 27 lb.in.
Fuel meter body attaching screw 35 lb.in.
Fuel inlet nuts to throttle body 30 lb.ft.
Fuel outlet nuts to throttle body 21 lb.ft.
Front fuel tank retaining strap bolts 26 lb.ft.
Rear fuel tank retaining strap bolts 8 lb.ft.
Idle Air Control Valve (IAC) 13 lb.ft.
TBI attaching bolts 16 lb.ft.
TPS attaching screws 18 lb.in.
Rear fuel tank retaining strap bolts 8 lb.ft.
Fuel level sender attaching nuts 27 lb.in.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.