Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1993CAPRICE WAGON RWD V6-262 4.3LREPAIR AND DIAGNOSISMAINTENANCEALIGNMENTSERVICE AND REPAIRFRONT CAMBER ADJUSTMENT
1993 Chevrolet Caprice Wagon RWD V6-262 4.3L
Front Camber Adjustment
1993 Chevrolet Caprice Wagon RWD V6-262 4.3LSECTION Front Camber Adjustment
Fig. 1 Caster & Camber Adjustments:
Camber adjustments are made by means of shims between the upper control arm inner support shaft and the support bracket attached to the frame, Fig. 1. Shims may be added, subtracted or transferred to change the readings.
Change shims at both the front and rear of the shaft. Adding an equal number of shims at both front and rear of the support shaft will decrease positive camber. One shim (1/32 inch) at each location will move camber approximately 1/6 degree.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.