Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1992S10/T10 P/U 2WD V6-173 2.8LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTRANSMISSION POSITION SENSOR/SWITCHADJUSTMENTS
1992 Chevrolet S10/T10 P/U 2WD V6-173 2.8L
Transmission Position Sensor/Switch: Adjustments
1992 Chevrolet S10/T10 P/U 2WD V6-173 2.8LSECTION Adjustments
PNPS - PARK/NEUTRAL POSITION SWITCH:
1. Move the switch housing all the way toward "Low Gear" position.
2. Move the gear selector to "Park" position. The switch housing and housing back should ratchet, providing proper switch adjustment.
3. Check for proper starting in "Neutral" and "Park". Check Backup lights for proper operation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.