Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1992S10/T10 P/U 2WD V6-173 2.8LREPAIR AND DIAGNOSISMAINTENANCEALIGNMENTSERVICE AND REPAIRFRONT TOE ADJUSTMENT
1992 Chevrolet S10/T10 P/U 2WD V6-173 2.8L
Front Toe Adjustment
1992 Chevrolet S10/T10 P/U 2WD V6-173 2.8LSECTION Front Toe Adjustment
Fig. 2 Tie Rod & Clamp Sleeve Positioning:
- To adjust, loosen clamp bolts at each end of steering tie rod adjustable sleeves.
- With steering wheel in straight ahead position, turn tie rod adjusting sleeves to obtain proper adjustment.
- After adjusting, check that number of threads showing on each end of sleeve are equal and that the tie rod end housings are at the right angles to steering arm.
- Position tie rod clamps and sleeves, Fig. 2, and torque nuts to specification.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.