Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1992S10/T10 P/U 2WD V6-173 2.8LREPAIR AND DIAGNOSISDIAGRAMSELECTRICAL DIAGRAMSPOWERTRAIN MANAGEMENTSYSTEM DIAGRAMELECTRONIC/POWERTRAIN CONTROL MODULE (ECM/PCM)
1992 Chevrolet S10/T10 P/U 2WD V6-173 2.8L
Electronic/Powertrain Control Module (ECM/PCM)
1992 Chevrolet S10/T10 P/U 2WD V6-173 2.8LSECTION Electronic/Powertrain Control Module (ECM/PCM)
ECM Wiring Diagram (Part 1 Of 3):
A8 = SERIAL DATA.
A9 = DIAGNOSTIC TEST.
A12 = SYSTEM GROUND.
D6 = OXYGEN SENSOR GROUND.
D1 = SYSTEM GROUND.
C9 = CRANK SIGNAL.
D7 = OXYGEN SENSOR SIGNAL.
A11 = MAP GROUND.
C11 = MAP SIGNAL.
C14 = +5 VOLT REFERENCE.
C13 = TPS SIGNAL.
D2 = SENSOR GROUND.
C10 = CTS SIGNAL.
B8 = A/C REQUEST SIGNAL.
A2 = A/C RELAY CONTROL.
ECM Wiring Diagram (Part 2 Of 3):
C5 = IAC COIL "A" HIGH.
C6 = IAC COIL "A" LOW.
C4 = IAC COIL "B" HIGH.
C3 = IAC COIL "B" LOW.
A6 = IGNITION FEED.
D16 = INJECTOR DRIVER.
D14 = INJECTOR DRIVER.
B3 = REFERENCE LOW.
D5 = BYPASS.
B5 = REFERENCE HIGH.
D4 = EST.
B1 = IGNITION FEED.
C16 = IGNITION FEED.
A1 = FUEL PUMP RELAY DRIVE (12 VOLT)
B2 = FUEL PUMP SIGNAL.
ECM Wiring Diagram (Part 3 Of 3):
A5 = SERVICE ENGINE SOON LIGHT CONTROL.
A7 = MANUAL TRANS SHIFT LAMP.
C2 = EAC SOLENOID.
A6 = IGNITION FEED.
A10 = VSS SIGNAL.
B7 = KNOCK RETARD SIGNAL (ESC).
A6 = IGNITION FEED.
A4 = EGR CONTROL.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.