Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1992LUMINA V6-204 3.4L DOHCREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSWINDOW REGULATORSERVICE AND REPAIRDOOR LOCKSLOCK MODULESEDAN
1992 Chevrolet Lumina V6-204 3.4L DOHC
Sedan
1992 Chevrolet Lumina V6-204 3.4L DOHCSECTION Sedan
Door Lock System:
Remove or Disconnect
1. Door trim panel.
2. Water deflector.
3. Lock cylinder to lock rod.
4. Screws.
5. Rivets by punching out mandrel, then using a 3/16 inch drill bit.
6. Power lock connector.
7. Lock module.
8. Handle to lock rod, if replacing lock module.
Install or Connect
1. Handle to lock rod, if removed.
2. Lock module in position through access hole in door inner panel.
A. Install handle to lock rod to handle lever.
B. Align module to holes in door facing.
NOTICE: It is required that while performing step 3 that the lock assembly be held tight against door facing while installing screws. All screws must be driven at a 90° angle to door facing to prevent cross threading or stripping of screws or door lock attaching holes. it is also required to tighten screws to specified torque of 7 N.m (62 lb in).
3. Screws.
Tighten
^ Screws to 7 N.m (62 lb in).
4. Power lock connector.
5. Rivets using 3/16 inch x 1/4 inch peel type rivets.
6. Lock cylinder to lock rod.
Inspect
^ Lock system for proper operation.
7. Water deflector.
8. Trim panel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.