Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1992LUMINA APV V6-3800 3.8LREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - POWERTRAIN MANAGEMENTRELAYS AND MODULES - COMPUTERS AND CONTROL SYSTEMSENGINE CONTROL MODULETESTING AND INSPECTION
1992 Chevrolet Lumina APV V6-3800 3.8L
Engine Control Module: Testing and Inspection
1992 Chevrolet Lumina APV V6-3800 3.8LSECTION Testing and Inspection
Diagnostic Circuit:
Circuit Description:
The Diagnostic Circuit Check must be the starting point for any driveability complaint diagnosis. Before using this you should perform a careful visual/physical check of the PCM and engine grounds for being clean and tight.
The diagnostic circuit check is an organized approach to identifying a problem created by an electronic engine control system malfunction because it directs the service technician to the next logical step in diagnosing the complaint.
Diagnostic Circuit Check:
Test Description:
Number(s) below refer to circled number(s) on the diagnostic chart.
1. The "Service Engine Soon" light should be "ON" steady with the key "ON"/Engine "OFF."
2. This test ensures that the PCM recognizes the diagnostic request signal from the ALDL and is controlling the "Service Engine Soon" light properly.
3. If an invalid code is displayed, the Tech 1, PCM or MEM-CAL can be at fault. "Flashing" the code by grounding ALDL terminal "B" isolates the cause of the invalid code.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.