Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1992CAMARO V8-305 5.0L VIN EREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSWINDOW REGULATORSERVICE AND REPAIRWITH POWER WINDOWSWINDOW GUIDE CAM
1992 Chevrolet Camaro V8-305 5.0L VIN E
Window Guide Cam
1992 Chevrolet Camaro V8-305 5.0L VIN ESECTION Window Guide Cam
Window Guide Cam:
Installing Window Guide Cam:
REMOVE OR DISCONNECT
1. Raise the window up halfway.
2. Water deflector.
3. Bolts (36) retaining the window guide cam (34) to the door inner panel.
4. Window guide cam (34) by pulling up and back and rotating 180 degrees.
5. Window guide cam (34) through rear access hole.
INSTALL OR CONNECT
1. Window guide cam (34) through rear access hole.
2. Window guide cam (34) to window regulator cam and door inner panel.
3. Bolts (36) retaining window guide cam (34) to door inner panel.
^ Tighten bolts (36) to 11 N.m (97 lb in).
4. Water deflector.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.