Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1991SUBURBAN 1/2 TON 4WD V8-350 5.7LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTRELAYS AND MODULES - POWERTRAIN MANAGEMENTRELAYS AND MODULES - COMPUTERS AND CONTROL SYSTEMSENGINE CONTROL MODULESERVICE AND REPAIRTHROTTLE BODY FUEL INJECTION
1991 Chevrolet Suburban 1/2 Ton 4WD V8-350 5.7L
Throttle Body Fuel Injection
1991 Chevrolet Suburban 1/2 Ton 4WD V8-350 5.7LSECTION Throttle Body Fuel Injection
When replacing a production ECM/PCM with a service ECM/PCM, transfer the broadcast code and production number from the production unit to the service unit. Also during replacement, the PROM, CALPACK, and if equipped, the MEMCAL must be removed from the ECM/PCM being replaced and transferred to the new unit. Refer to PROM, CALPAK and MEMCAL in this section for replacement procedures.
1. Disconnect battery ground cable.
2. Then disconnect two computer electrical connectors.
3. Remove computer mounting hardware.
4. Remove computer from passenger compartment.
5. Reverse procedure to install.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.