Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1991CAPRICE WAGON RWD V8-350 5.7LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTIGNITION SYSTEMRELAYS AND MODULES - IGNITION SYSTEMIGNITION CONTROL MODULESERVICE AND REPAIR
1991 Chevrolet Caprice Wagon RWD V8-350 5.7L
Ignition Control Module: Service and Repair
1991 Chevrolet Caprice Wagon RWD V8-350 5.7LSECTION Service and Repair
REMOVAL
1. Remove distributor cap and rotor.
2. Remove pick up coil.
3. Remove two module attaching screws, and lift module up.
4. Disconnect leads from module. Observe color code on leads as these cannot be interchanged.
5. Remove module.
INSTALLATION
NOTE: Be sure there is a sufficient amount of silicone grease on the metal face of the module and on the distributor base (where the module seats), when reinstalling the module. The purpose of the silicone grease is to cool the module.
1. Install module.
2. Connect leads to module.
3. Install module attaching screws.
4. Install pick up coil.
5. Install cap and rotor.
1. Remove distributor cap and rotor.
2. Remove pick up coil.
3. Remove two module attaching screws, and lift module up.
4. Disconnect leads from module. Observe color code on leads as these cannot be interchanged.
5. Remove module.
INSTALLATION
NOTE: Be sure there is a sufficient amount of silicone grease on the metal face of the module and on the distributor base (where the module seats), when reinstalling the module. The purpose of the silicone grease is to cool the module.
1. Install module.
2. Connect leads to module.
3. Install module attaching screws.
4. Install pick up coil.
5. Install cap and rotor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.