Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1990S10/T10 P/U 4WD V6-262 4.3LREPAIR AND DIAGNOSISMAINTENANCEALIGNMENTSPECIFICATIONSALIGNMENT SPECIFICATIONS
1990 Chevrolet S10/T10 P/U 4WD V6-262 4.3L
Alignment Specifications
1990 Chevrolet S10/T10 P/U 4WD V6-262 4.3LSECTION Alignment Specifications
FRONT ALIGNMENT SPECIFICATIONS
(Figure 1) Front End Alignment Specifications:
NOTE: Vehicle must be jounced three times before checking alignment to eliminate false geometry readings.
(A) Front suspension "Z" dimension and rear suspension "D" dimension are held as indicated in Trim Height Measurements. Ride/Trim Height Measurement and Adjustment
Front end alignment specifications are indicated in image.
(B) Left and right side to be equal within 0.50 degree.
(C) Left and right side to be equal within 1.0 degree.
(D) Toe-in-left and right side to be set separately per wheel and steering wheel must be held in straight ahead position within ± 5.0 degree.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.