Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1990S10/T10 P/U 2WD V6-173 2.8LREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSWINDOW REGULATORSERVICE AND REPAIRWITH POWER WINDOWSDOOR ARMREST REPLACEMENT
1990 Chevrolet S10/T10 P/U 2WD V6-173 2.8L
Door Armrest Replacement
1990 Chevrolet S10/T10 P/U 2WD V6-173 2.8LSECTION Door Armrest Replacement
Front Door Trim Panel:
REMOVE OR DISCONNECT
1. Screws securing the armrest to the door trim.
2. Armrest from the door trim.
^ Slide the armrest towards the rear of the door, and then, lift the armrest from the door.
INSTALL OR CONNECT
1. Armrest to the door trim.
^ Place the armrest retaining clips in the slots on the door panel.
^ Slide the armrest toward the front of the door unit the holes in the armrest align with the holes in the door trim.
2. Screws securing the armrest to the door trim.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.