Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1989R 20 P/U 2WD V8-454 7.4LREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSCLUTCH, M/TSYSTEM SPECIFICATIONS
1989 Chevrolet R 20 P/U 2WD V8-454 7.4L
System Specifications
1989 Chevrolet R 20 P/U 2WD V8-454 7.4LSECTION System Specifications
FASTENER TIGHTENING SPECIFICATIONS
Flywheel Housing to Engine 54 Nm (40 lbs. ft.)
Clutch Pedal Stud 39 Nm (29 lbs. ft.)
Master Cylinder 18 Nm (13 lbs. ft.)
Secondary (Slave) Cylinder 18 Nm (13 lbs. ft.)
Cross Lever Ball Stud:
Bracket Side 27 Nm (20 lbs. ft.)
Engine Side 46 Nm (34 lbs. ft.)
Adjusting Rod Swivel 27 Nm (20 lbs. ft.)
Flywheel to Crankshaft Bolts 90 Nm (65 lbs. ft.)
Clutch Cover to Flywheel......Tighten each screw one turn at a time to avoid warping the clutch cover.
NOTE: The OE service manual does not provide a tightening specification for the clutch cover to flywheel screws.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.