Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1987S10/T10 P/U 2WD V6-173 2.8LREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSWINDOW HANDLESERVICE AND REPAIR
1987 Chevrolet S10/T10 P/U 2WD V6-173 2.8L
Window Handle: Service and Repair
1987 Chevrolet S10/T10 P/U 2WD V6-173 2.8LSECTION Service and Repair
Front Door Window Regulator Handle:
TOOL REQUIRED:
J-9886-O1, Door Handle Remover.
REMOVE OR DISCONNECT
1. Window regulator handle.
^ Insert J-9886-O1 between the handle and the bearing plate.
^ Align the tool parallel with the door handle, and push to disengage the clip.
^ Pull the handle from the door.
2. Bearing plate.
INSTALL OR CONNECT
1. Bearing plate.
2. Window regulator handle.
^ Place the window in the raised position.
^ Put the clip onto the handle,
^ Insert the handle onto the door so the handle is pointing towards the front of the door.
^ Push on the handle until the clip engages the window regulator shaft.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.