Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1987S10/T10 P/U 2WD V6-173 2.8LREPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINAUTOMATIC TRANSMISSION/TRANSAXLESERVICE AND REPAIROVERHAUL700-R4 AUTOMATIC TRANSMISSIONSUBASSEMBLY SERVICECASE & INTERNAL COMPONENTSREVERSE INPUT & INPUT CLUTCHES
1987 Chevrolet S10/T10 P/U 2WD V6-173 2.8L
Reverse Input & Input Clutches
1987 Chevrolet S10/T10 P/U 2WD V6-173 2.8LSECTION Reverse Input & Input Clutches
1. Install selective thrust washer onto the input housing.
2. Install bearing assembly with inside (black race) facing toward the oil pump.
3. Install reverse input clutch assembly onto the input clutch assembly. Ensure all clutches are fully engaged.
4. Install reverse input and input clutch assembly into transmission case. Ensure all clutches are fully engaged. When properly assembled, the reverse input clutch housing should be located just below the case oil pump face.
2. Install bearing assembly with inside (black race) facing toward the oil pump.
3. Install reverse input clutch assembly onto the input clutch assembly. Ensure all clutches are fully engaged.
4. Install reverse input and input clutch assembly into transmission case. Ensure all clutches are fully engaged. When properly assembled, the reverse input clutch housing should be located just below the case oil pump face.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.