Severe Service Defined

1987 Chevrolet Chevette L4-98 1.6LSECTION Severe Service Defined
SEVERE SERVICE DEFINED
1. Trips of 5 miles (8 kilometers) or less.
2. Trips of 10 miles (16 kilometers) or less and the outside temperature remains below 32° Fahrenheit.
3. Trailer towing.
4. Operating in dusty, sandy or salty areas.
5. Extended idling conditions or low speed operation such as stop and go traffic.
6. Extended driving in excessive temperature conditions (above 50% at 90° Fahrenheit).
7. When vehicle is used for delivery services, police, taxi or other commercial applications.
8. Driving continuously in excess of normal highway speeds.

NOTES:
Some vehicle manufacturers provide separate maintenance procedures for vehicles operated under Severe or Special circumstances. Other manufacturers provide recommendations for service at more frequent intervals for vehicles operated under severe conditions. For any vehicle operated under severe conditions, as defined by the vehicles manufacturer, always check the regular maintenance schedule for procedures that may not appear at the similar interval under severe service, see Example 1.

Example 1:
Manufacturer recommends tire rotation at 10,000 mile intervals under regular maintenance. There is no tire rotation recommendation shown in the severe service schedule, which has 3,000 mile intervals.

At a minimum, recommend rotation at 9,000 and 18,000 mile intervals etc., or as close to the regular schedule as possible. Depending on vehicle usage and obvious tire wear, this recommendation should be increased as necessary.

Also, some vehicle manufacturers provide only a single schedule (Normal) for all driving conditions. Some of the components listed in the schedule may have notes describing alternate service intervals for that component depending on driving conditions, see Example 2.

Example 2:
Many vehicles have an "Engine Oil Life Monitor" lamp which can illuminate anytime between intervals depending on driving conditions. The oil should then be replaced at that time, regardless of mileage, and the "Engine Oil Life Monitor" reset.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.