Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1986S10/T10 P/U 4WD L4-151 2.5LREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGCOMPRESSOR HVACSERVICE AND REPAIRCOMPRESSOR REPLACEMENT
1986 Chevrolet S10/T10 P/U 4WD L4-151 2.5L
Compressor Replacement
1986 Chevrolet S10/T10 P/U 4WD L4-151 2.5LSECTION Compressor Replacement
S/T-10/15
4 CYL. ENGINES
1. Disconnect battery ground cable, then discharge system refrigerant.
2. Disconnect compressor harness leads.
3. Remove power steering pump bracket to engine brace.
4. Loosen air cleaner and move to side.
5. Remove A/C bracket to engine brace.
6. Remove compressor mounting bolts.
7. Remove manifold at rear of compressor and drive belt.
8. Remove compressor.
9. Reverse procedure to install.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.