Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1986G 20 VAN V8-379 6.2L DSLREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTPROM - PROGRAMMABLE READ ONLY MEMORYSERVICE AND REPAIREEPROM
1986 Chevrolet G 20 Van V8-379 6.2L DSL
EEPROM
1986 Chevrolet G 20 Van V8-379 6.2L DSLSECTION EEPROM
CAUTION:
The Erasable Programmable Read Only Memory (EEPROM) is a permanent memory that is physically soldered to the circuit boards within the computer. It is not serviceable and should not be removed for replacement. If COMPUTER replacement is performed, reprogramming of the EEPROM will be necessary. Failure to do this will cause the vehicle to have a no start or poor running condition. Reprogramming of the EEPROM is only possible with the Service Stall System (SSS) hardware available at authorized dealer locations. Check with a dealer before performing COMPUTER replacement or EEPROM reprogramming.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.