Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1986CAPRICE WAGON V8-307 5.0LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSSERVICE PRECAUTIONSTECHNICIAN SAFETY INFORMATION
1986 Chevrolet Caprice Wagon V8-307 5.0L
Technician Safety Information
1986 Chevrolet Caprice Wagon V8-307 5.0LSECTION Technician Safety Information
NOTE: Various "WARNING:" and "CAUTION:" messages are contained throughout this manual, to indicate potentially hazardous conditions that may be present when performing certain services or repairs. Be sure to read, understand, and adhere to these precautions before performing the described services.
ADDITIONAL GENERAL SAFETY PRECAUTIONS
1. Always wear appropriate eye protection.
2. Use caution when working near the catalytic converter to prevent the possibility of burns. The temperatures within the converter can exceed 1000°F.
3. Ignition systems present a shock hazard; exercise care when performing spark test and always use non-conductive ignition wire pliers.
4. When servicing the fuel system use the following cautions:
a. Put a "CAUTION: FLAMMABLE" sign in the workshop.
b. Be sure to furnish the shop with the proper fire extinguisher.
c. Be sure to disconnect battery ground cable before any service work is done.
d. Place a suitable container under the connection to be opened.
e. On vehicles with port or throttle body fuel injection, always relieve fuel system pressure prior to disconnecting fuel system components. Slowly open connection, allow pressure to escape, and catch spilled fuel in container.
NOTE: If available, use system bleed valve (schrader) to relieve pressure.
f. Disconnect line or hose, then plug all fittings.
g. Put any drained fuel in an explosive-proof container and put the lid on securely.
ADDITIONAL GENERAL SAFETY PRECAUTIONS
1. Always wear appropriate eye protection.
2. Use caution when working near the catalytic converter to prevent the possibility of burns. The temperatures within the converter can exceed 1000°F.
3. Ignition systems present a shock hazard; exercise care when performing spark test and always use non-conductive ignition wire pliers.
4. When servicing the fuel system use the following cautions:
a. Put a "CAUTION: FLAMMABLE" sign in the workshop.
b. Be sure to furnish the shop with the proper fire extinguisher.
c. Be sure to disconnect battery ground cable before any service work is done.
d. Place a suitable container under the connection to be opened.
e. On vehicles with port or throttle body fuel injection, always relieve fuel system pressure prior to disconnecting fuel system components. Slowly open connection, allow pressure to escape, and catch spilled fuel in container.
NOTE: If available, use system bleed valve (schrader) to relieve pressure.
f. Disconnect line or hose, then plug all fittings.
g. Put any drained fuel in an explosive-proof container and put the lid on securely.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.