Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1986C 10 P/U 2WD V8-350 5.7LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTIGNITION SYSTEMIGNITION TIMINGADJUSTMENTSFEDERAL
1986 Chevrolet C 10 P/U 2WD V8-350 5.7L
Federal
1986 Chevrolet C 10 P/U 2WD V8-350 5.7LSECTION Federal
IGNITION TIMING PROCEDURE
1. Warm engine to normal operating temperature (upper radiator hose hot).
2. Place transmission in Neutral or Park. Apply parking brake and block wheels.
3. Choke must be open.
4. Connect tachometer and an inductive timing light to number one spark plug wire.
5. Disconnect and plug distributor vacuum advance hose.
6. Check ignition timing and compare to specification. Ignition Timing
7. If timing is not to specification, adjust as follows:
- Loosen distributor hold-down bolt and rotate distributor until timing mark on pulley or damper is aligned with specified degree on timing scale.
- Retighten the hold-down bolt and recheck timing.
8. Remove test equipment and reconnect vacuum line to distributor advance.
1. Warm engine to normal operating temperature (upper radiator hose hot).
2. Place transmission in Neutral or Park. Apply parking brake and block wheels.
3. Choke must be open.
FIRING ORDER:
4. Connect tachometer and an inductive timing light to number one spark plug wire.
5. Disconnect and plug distributor vacuum advance hose.
6. Check ignition timing and compare to specification. Ignition Timing
7. If timing is not to specification, adjust as follows:
- Loosen distributor hold-down bolt and rotate distributor until timing mark on pulley or damper is aligned with specified degree on timing scale.
- Retighten the hold-down bolt and recheck timing.
8. Remove test equipment and reconnect vacuum line to distributor advance.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.