Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1986C 10 P/U 2WD V8-350 5.7LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSADJUSTMENTSFAST IDLE SPEED
1986 Chevrolet C 10 P/U 2WD V8-350 5.7L
Fast Idle Speed
1986 Chevrolet C 10 P/U 2WD V8-350 5.7LSECTION Fast Idle Speed
Check and, if necessary, adjust ignition timing before adjusting fast idle speed. Make all adjustments with engine at normal operating temperature, choke fully open, air cleaner installed and A/C control off, if equipped.
1. Disconnect and plug vacuum hoses as directed on vehicle emission control label.
2. Position fast idle screw on specified step of fast idle cam as directed on vehicle emission control label.
3. Turn fast idle screw in or out and adjust fast idle speed to specifications.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.