Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1985S10/T10 BLAZER 4WD L4-151 2.5LREPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINDIFFERENTIAL ASSEMBLYSPECIFICATIONSREAR AXLE SPECIFICATIONS
1985 Chevrolet S10/T10 Blazer 4WD L4-151 2.5L
Rear Axle Specifications
1985 Chevrolet S10/T10 Blazer 4WD L4-151 2.5LSECTION Rear Axle Specifications
Rear Axle, Bearing Specifications
<cfbgm-060>
<cfbgm-060>
| Carrier Type | Integral | |
| Ring Gear & Pinion Backlash | Method | Shim |
| Adjustment | 0.005-0.009 | |
| Pinion Bearing Preload | Method | Spacer |
| New Bearings | 24-32 Note: Measured with torque wrench at pinion flange nut | |
| Used Bearings | 8-12 Note: Measured with torque wrench at pinion flange nut | |
| Differential Bearing Preload | Method | Shim |
| New Bearings | - Note: Slip fit plus .004 inch preload on each side | |
| Used Bearings | - Note: Slip fit plus .004 inch preload on each side |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.