Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1985S10/T10 BLAZER 4WD L4-151 2.5LREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSTRANSMISSION AND DRIVETRAINSYSTEM SPECIFICATIONSTRANSFER CASETIGHTENING SPECIFICATIONSNEW PROCESS MODEL 208
1985 Chevrolet S10/T10 Blazer 4WD L4-151 2.5L
New Process Model 208
1985 Chevrolet S10/T10 Blazer 4WD L4-151 2.5LSECTION New Process Model 208
Lockplate Attaching Bolts 30 lb ft
Operating Lever To Range Sector Shaft Locknut 18 lb ft
Front to Rear Case Bolts 23 lb ft
Retainer Attaching Bolts 23 lb ft
Indicator Switch 18 lb ft
Detent Retainer Bolt 23 lb ft
Drain and Fill Plug 18 lb ft
Yoke Nuts 120 lb ft
Operating Lever To Range Sector Shaft Locknut 18 lb ft
Front to Rear Case Bolts 23 lb ft
Retainer Attaching Bolts 23 lb ft
Indicator Switch 18 lb ft
Detent Retainer Bolt 23 lb ft
Drain and Fill Plug 18 lb ft
Yoke Nuts 120 lb ft
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.