Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1985S10/T10 BLAZER 4WD L4-151 2.5LREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSTRANSMISSION AND DRIVETRAINSYSTEM SPECIFICATIONSTRANSFER CASETIGHTENING SPECIFICATIONSNEW PROCESS MODEL 205
1985 Chevrolet S10/T10 Blazer 4WD L4-151 2.5L
New Process Model 205
1985 Chevrolet S10/T10 Blazer 4WD L4-151 2.5LSECTION New Process Model 205
Idler Shaft Locknut 150 lb ft
Idler Shaft Cover Bolts 20 lb ft
Yoke Locknut 150 lb ft
Bearing Retainer Assembly Bolts 30 lb ft
Power Takeoff Cover Bolts 15 lb ft
Drain And Filler Plugs 30 lb ft
Idler Shaft Cover Bolts 20 lb ft
Yoke Locknut 150 lb ft
Bearing Retainer Assembly Bolts 30 lb ft
Power Takeoff Cover Bolts 15 lb ft
Drain And Filler Plugs 30 lb ft
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.