Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1985C 10 P/U 2WD V8-350 5.7LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTPROM - PROGRAMMABLE READ ONLY MEMORYDESCRIPTION AND OPERATIONCALPAK
1985 Chevrolet C 10 P/U 2WD V8-350 5.7L
CALPAK
1985 Chevrolet C 10 P/U 2WD V8-350 5.7LSECTION CALPAK
CAUTION:
If the computer is found to be defective and needs replacement, remove the old CALPAK and PROM, then place both into the replacement computer. When replacing the COMPUTER always transfer the BROADCAST CODE and PRODUCTION ECM/PCM NUMBER to the service label on the replacement computer.
DESCRIPTION:
The resistor network calibration called a CALPAK is located inside the computer. Its appearance and service is similar to the PROM. The CALPAK allows fuel to be delivered if other parts of the computer fail. The CALPAK provides the computer with calibrations for:
^ Cold Start Cranking.
^ Limp home fuel (fuel backup mode).
If the computer is found to be defective and needs replacement, remove the old CALPAK and PROM, then place both into the replacement computer. When replacing the COMPUTER always transfer the BROADCAST CODE and PRODUCTION ECM/PCM NUMBER to the service label on the replacement computer.
DESCRIPTION:
The resistor network calibration called a CALPAK is located inside the computer. Its appearance and service is similar to the PROM. The CALPAK allows fuel to be delivered if other parts of the computer fail. The CALPAK provides the computer with calibrations for:
^ Cold Start Cranking.
^ Limp home fuel (fuel backup mode).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.