Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1985BLAZER FULL SIZE V8-350 5.7LREPAIR AND DIAGNOSISMAINTENANCEFLUIDSTECHNICAL SERVICE BULLETINS
1985 Chevrolet Blazer Full Size V8-350 5.7L
Fluids: Technical Service Bulletins
1985 Chevrolet Blazer Full Size V8-350 5.7LSECTION Technical Service Bulletins
- Customer Interest
- By Symptom
- All Technical Service Bulletins
- A/C Refrigerant - Contamination
- Engine Oil - Discoloration (Oil Dye)
- Maintenance - Updated Minimum Acceptable Oil Levels
- Cooling System - Reconstituted Anti-Freeze Information
- Coolant - Information on Propylene Glycol Usage
- Warranty - Recycled Engine Coolant Policy
- Coolant - Used Anti-Freeze Policy
- A/T - New Trans Fluid, Dexron IIE
- A/T - DEXRON III Fluid Introduction
- Locking Differential - Chattering on Turns
- Drivetrain - Recommended Axle Lubricant
- A/C - Use of Alternate Refrigerants In CFC 12
- Contaminated R12 Refrigerant - Testing & Handling
- A/C - Retrofitting R-12 Vehicles to R-134A
- P/S - Reduced Assist When Cold
- Cooling System - Coolant Recycling Information
- A/T - Water Or Coolant Contamination Information
- A/T - DEXRON(R)-VI Fluid Information
- Power Steering - Fluid Leaks Due to Extreme Low Temps
- A/T - Fluid Oil Cooler Flow Test
- Engine - GM Dexos 1(R) And 2(R) Oil Specifications
- Engine - GM dexos 1(R) and dexos 2(R) Oil Specifications/Info.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.