Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1984CORVETTE V8-350 5.7LREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSWINDOW GLASSSERVICE AND REPAIR
1984 Chevrolet Corvette V8-350 5.7L
Window Glass: Service and Repair
1984 Chevrolet Corvette V8-350 5.7LSECTION Service and Repair
WINDOW GLASS
Removal
1. Disconnect battery ground cable.
2. Remove armrest.
3. Remove speaker grille.
4. Remove door trim panel as previously described.(Body and frame/doors hood and trunk/door/door panel)Doors
5. Remove water separator.
6. Mark location and loosen anti-rattle pads (2). Move to facilitate glass removal.
7. Move regulator. into position to access glass nut holes in inner mounting plate.
8. Mark position and remove stabilizing guide and glass top.
9. Remove (3) glass to regulator nuts. Remove glass, remove studs and stop on glass through slot at top. of door.
Installation
If replacement of glass is necessary, transfer studs... and stop to new glass. Reverse removal procedure to install glass. Adjust as necessary and clean glass.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.