Generator Replacement

1984 Chevrolet Blazer Full Size V8-379 6.2L DSLSECTION Generator Replacement




Remove

1. Disconnect negative battery terminal at battery.

CAUTION: Failure to observe this step may result in an injury from hot battery lead at generator.

2. Remove two terminal plug and battery leads on back of generator.

Generator Mounting - LE8/LT9:





Generator Mounting - LE3:





Generator Mounting - L25:





Generator Mounting - Diesel:





Generator Mounting - P300 (42) L25:






3. Loosen adjusting bolts.
4. Remove generator drive belt.
5. Remove thru bolt which retains generator.
6. Remove generator from vehicle.

Install

1. If remove from vehicle, install generator to mounting bracket with bolts, washer and nuts. Do not tighten.
2. Install generator drive belt.
3. Tighten belt to the specified belt tension .
4. Tighten bolts.
5. Install generator terminal plug and battery leads to generator.
6. Connect negative battery terminal.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.