Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1984BLAZER FULL SIZE V8-350 5.7LREPAIR AND DIAGNOSISCRUISE CONTROLCRUISE CONTROL SERVO CABLEADJUSTMENTS
1984 Chevrolet Blazer Full Size V8-350 5.7L
Cruise Control Servo Cable: Adjustments
1984 Chevrolet Blazer Full Size V8-350 5.7LSECTION Adjustments
Servo Unit Adjustment
To adjust servo on six cylinder engines, use second (6-292) or third (6-250) ball on servo chain. With throttle closed and ignition and fast idle off, adjust cable jam nuts until .040 inch clearance exists between lever pin and cable assembly end slots. Tighten jam nuts.
To adjust servo on V8 gasoline engines, close throttle, then with ignition and fast idle off, adjust rod assembly length to give .007---.015 inch clearance between rod and stud.
To adjust servo on V8 diesel engines, position idle screw against stop, then with engine off, assemble lower end of rod link to throttle lever and upper end to hole closest servo which will provide .040 inch slack minimum.
Engagement-Cruising Speed Zeroing
There is no provision for engagement-cruising speed zeroing. If cruising speed is too high or low, check vacuum hoses for improper routing, restrictions or leaks and servo linkage for proper adjustment. If cruising speed is still too high or low, replace the electronic controller.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.