Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1982S10,T10 P/U,BLAZER V6-173 2.8LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTECHNICAL SERVICE BULLETINSALL TECHNICAL SERVICE BULLETINSIDLE SPEED CONTROL ASSEMBLY - REPAIR KIT
1982 Chevrolet S10,T10 P/U,Blazer V6-173 2.8L
Idle Speed Control Assembly - Repair Kit
1982 Chevrolet S10,T10 P/U,Blazer V6-173 2.8LSECTION Idle Speed Control Assembly - Repair Kit
83chevy7
Number: 82-I-144
Section: VIm
Date: Mar., 1983
Subject: IDLE SPEED CONTROL ASSEMBLY REPAIR KIT - 1981-82 ALL
TO: ALL CHEVROLET DEALERS
A revised gear and shaft has been released for 1982 production idle speed control assemblies. Idle speed control assemblies with the new gear and shaft may be identified by a yellow dot on the housing near the shaft.
In order to provide these improvements to the service assemblies, two (2) separate service repair packages have been re leased to repair 1981 and 1982 idle speed control assemblies (ISC). Applications are as follows:
P/N Application
17079749 For Cavalier series equipped
with engine Code "G"
17079750 All other engines
The repair kits contain a gear and shaft assembly, a boot, grease and an instruction sheet.
The repair packages are to be used if the following conditions exist:
^ Idle speed control assembly runs forward and reverse, but plunger does not extend or retract properly.
Number: 82-I-144
Section: VIm
Date: Mar., 1983
Subject: IDLE SPEED CONTROL ASSEMBLY REPAIR KIT - 1981-82 ALL
TO: ALL CHEVROLET DEALERS
A revised gear and shaft has been released for 1982 production idle speed control assemblies. Idle speed control assemblies with the new gear and shaft may be identified by a yellow dot on the housing near the shaft.
In order to provide these improvements to the service assemblies, two (2) separate service repair packages have been re leased to repair 1981 and 1982 idle speed control assemblies (ISC). Applications are as follows:
P/N Application
17079749 For Cavalier series equipped
with engine Code "G"
17079750 All other engines
The repair kits contain a gear and shaft assembly, a boot, grease and an instruction sheet.
The repair packages are to be used if the following conditions exist:
^ Idle speed control assembly runs forward and reverse, but plunger does not extend or retract properly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.