Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1982S10,T10 P/U,BLAZER V6-173 2.8LREPAIR AND DIAGNOSISCRUISE CONTROLCRUISE CONTROL SERVO CABLEADJUSTMENTS
1982 Chevrolet S10,T10 P/U,Blazer V6-173 2.8L
Cruise Control Servo Cable: Adjustments
1982 Chevrolet S10,T10 P/U,Blazer V6-173 2.8LSECTION Adjustments
1982 Models
With carburetor throttle completely closed (ignition ``Off'' and fast idle cam off), loosen cable adjustment jam nuts. Position cable so chain is almost tight (some slack), and tighten jam nuts.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.