Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1982CHEVETTE L4-98 1.6LREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGCOMPRESSOR HVACCOMPRESSOR SHAFT SEALSERVICE AND REPAIRREMOVAL
1982 Chevrolet Chevette L4-98 1.6L
Removal
1982 Chevrolet Chevette L4-98 1.6LSECTION Removal
Fig. 6 Replacing shaft seal seat & seal:
1. Discharge refrigerant and remove clutch plate and hub outlined previously.
2. Using tool J-5403-A, remove shaft seal seat retainer ring.
3. Remove shaft seal seat with tool J-23128-A, then the shaft seal with tool J-9392, Fig. 6.
4. Remove seal seat O-ring with tool J-9553-01.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.