Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1982CHEVETTE L4-111 1.8L DSLREPAIR AND DIAGNOSISLIGHTING AND HORNSBRAKE LIGHT SWITCHSERVICE AND REPAIR
1982 Chevrolet Chevette L4-111 1.8L DSL
Brake Light Switch: Service and Repair
1982 Chevrolet Chevette L4-111 1.8L DSLSECTION Service and Repair
1. Reach under right side of instrument panel at brake pedal support and release wiring harness connector at switch.
2. Pull switch from mounting bracket.
3. When installing switch, adjust by bringing brake pedal to normal position. Electrical contact should be made when pedal is depressed .53 inch (13.5 mm). To adjust, the switch may be rotated or pulled in the clip.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.