Turn Signal Switch: Service and Repair

1982 Chevrolet Celebrity L4-151 2.5LSECTION Service and Repair

Fig. 1 Compressing lock plate:





1. Disconnect battery ground cable.
2. Remove steering wheel as outlined under ``Steering Wheel, Replace'' procedure.
3. Using a screwdriver, pry cover from housing.
4. Using lock plate compressing tool J-23653, compress lock plate, and pry snap ring from groove on shaft, Fig. 1. Slowly release lock plate compressing tool, then remove tool and lock plate from shaft end.
5. Slide canceling cam and upper bearing preload spring from end of shaft.
6. Remove turn signal (multi-function) lever.
7. Remove hazard warning knob retaining screw, button, spring and knob.
8. Remove pivot arm.
9. Wrap upper part of electrical connector with tape to prevent snagging of wires during switch removal.
10. Remove switch retaining screws and pull switch up from column, guiding wire harness through column.
11. Reverse procedure to install.



RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.