Distributor Replacement

1982 Chevrolet Cavalier L4-112 1.8LSECTION Distributor Replacement
1. Disconnect battery ground cable.
2. Remove spark plug wires and ignition coil.
3. Disconnect distributor wiring.
4. Remove two nuts Securing distributor body to cylinder head and remove distributor.
5. Reverse procedure to install. Adjust ignition timing to specifications. Torque nuts to 9-15 ft. lbs.

NOTE: No gear is used to drive the distributor. A lug at the distributor base engages a slot on camshaft end.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.