Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1982CAMARO L4-151 2.5LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTEMISSION CONTROL SYSTEMSEXHAUST GAS RECIRCULATIONEGR VALVETESTING AND INSPECTION
1982 Chevrolet Camaro L4-151 2.5L
EGR Valve: Testing and Inspection
1982 Chevrolet Camaro L4-151 2.5LSECTION Testing and Inspection
Ported Vacuum & Negative Back Pressure EGR Valves
1. Check vacuum hoses for correct routing and EGR valve signal tube orifice for obstructions.
2. Connect vacuum gauge between EGR valve and carburetor--a minimum of 5 inches Hg vacuum should be available with engine running at normal operating temperature.
3. Depress valve diaphragm, then position finger over source tube. Release diaphragm.
4. Valve is good if diaphragm takes at least 20 seconds to move to closed position. If diaphragm closes in less than 20 seconds, replace EGR valve.
NOTE: On engines equipped with EGR thermal vacuum switch or solenoid, there should be no EGR valve movement below the calibration temperature. If movement occurs, check TVS or solenoid for proper operation.
Positive Back Pressure EGR Valve
1. Check vacuum hoses for correct routing and EGR valve signal tube orifice for obstructions.
2. Remove EGR valve from vehicle, and apply a constant vacuum of 10 inches Hg to EGR valve signal tube while observing position of valve. If valve is not closed, replace EGR valve.
3. With vacuum supply still applied, direct a low pressure stream of air into EGR valve exhaust inlet. Valve should open. If not, replace EGR valve.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.