Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1982CAMARO L4-151 2.5LREPAIR AND DIAGNOSISLIGHTING AND HORNSTURN SIGNALSTURN SIGNAL SWITCHSERVICE AND REPAIR
1982 Chevrolet Camaro L4-151 2.5L
Turn Signal Switch: Service and Repair
1982 Chevrolet Camaro L4-151 2.5LSECTION Service and Repair
REMOVAL AND INSTALLATION OF TURN SIGNAL SWITCH:
Tools required:
J 23653-A Lock Plate Compressor
J 3568-A Terminal Remover
Remove or disconnect (Figures- 2,3,4,5,6,7)
NOTICE: Wheels of car must be straight ahead. Failure to do so may cause improper alignment during installation, resulting in column malfunction.
Key In "Lock" position. Failure to do will cause steering wheel to turn.
CAUTION:Disconnect battery. Failure to do me may cause electrical chock when working with wiring.
1. Horn pad and electrical connection
2. Retainer (1) and jam nut (2).
3. Steering wheel using J-1859-03
4. Shaft lock retaining spring (4) using J 2365-A to depress shaft lock (5)
5. Shaft-lock (5) and shaft lock cover (3)
6. Turn signal cancelling cam (6)
7. Upper bearing spring (7)
8. Upper bearing seat (12)
9. Inner race (13)
10. Turn signal to "right turn" position.
11. Screw (9) and signal switch arm (10)
12. Screws (8)
13. To remove turn signal switch
A. Wiring protector (54)
B. Hazard knob
C. Gently pull wire harness through column housing shroud (65) column housing (38), and lock housing cover (18).
14. . Reverse procedure to install.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.