Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1982CAMARO L4-151 2.5LREPAIR AND DIAGNOSISLIGHTING AND HORNSBRAKE LIGHT SWITCHSERVICE AND REPAIR
1982 Chevrolet Camaro L4-151 2.5L
Brake Light Switch: Service and Repair
1982 Chevrolet Camaro L4-151 2.5LSECTION Service and Repair
EXC. CORVETTE
1. On Camaro, remove hush panel.
2. On all models, disconnect wiring connector at switch.
3. Remove retaining nut, if so equipped, and unscrew switch from bracket.
4. To install: Depress brake pedal and push new switch into clip until shoulder bottoms out.
5. Plug connector onto switch and check operation. Electrical contact should be made when pedal is depressed 3/8 to 5/8 from fully released position.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.