Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC1999SEVILLE SLS V8-4.6L VIN YREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSCRANKSHAFT POSITION SENSORSERVICE AND REPAIR
1999 Cadillac Seville SLS V8-4.6L VIN Y
Crankshaft Position Sensor: Service and Repair
1999 Cadillac Seville SLS V8-4.6L VIN YSECTION Service and Repair
REMOVAL PROCEDURE
1. Raise the vehicle and support.
2. Remove the electrical connector at the cranksensor.
3. Remove the retaining bolt (1) and cranksensor (2 or 3).
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Cautions and Notices.
1. Install the cranksensor (2 or 3) and the retaining bolt (1).
Tighten
Tighten the retaining bolt to 10 N.m (89 lb in).
2. Install the electrical connector at the cranksensor.
3. Lower the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.