Inflatable Restraint Sensing and Diagnostic Module Replacement (With RPO Code AM6)

INFLATABLE RESTRAINT SENSING AND DIAGNOSTIC MODULE REPLACEMENT (WITH RPO CODE AM6)

REMOVAL PROCEDURE
1. Disable the SIR system. Refer to, SIR Disabling and Enabling Zone 8.

CAUTION: Do not strike or jolt the inflatable restraint sensing and diagnostic module (SDM). Before applying power to the SDM, make sure that it is securely fastened with the arrow facing toward the front of the vehicle. Failure to observe the correct installation procedure could cause SIR deployment, personal injury, or unnecessary SIR system repairs.

2. Remove the front seat.
3. Remove the rear carpet from vehicle.




4. Remove the connector position assurance (CPA) (1) from the inflatable restraint sensing and diagnostic module (SDM) wiring harness connector (2).
5. Push down flex lock button (3) and then move sliding connector locking cover (4) to the open position.




6. Remove the push-on clip (1) securing the SDM wiring harness to the console stud.
7. Disconnect the SDM wiring harness connector (3) from the SDM (2).




8. Remove the SDM mounting fasteners (1).
9. Remove the SDM (2) from the console floor (3).

INSTALLATION PROCEDURE
1. Remove any dirt, grease, or other impurities from the mounting surface.




2. Install the SDM (2) horizontally to console floor (3).
3. Point the arrow on the SDM toward the front of the vehicle.
4. Install the SDM mounting fasteners (1).

Tighten the fasteners to 9 N.m (80 lb in).

NOTE: Refer to Fastener Notice.




5. Connect the SDM wiring harness connector (3) to the SDM (2).
6. Install the push-on clip (1) securing the SDM wiring harness to the console stud.




7. Push down flex lock button (3) and then move sliding connector locking cover (4) to the close position.
8. Install the CPA (1) to the inflatable restraint SDM wiring harness connector (2).
9. Install the rear carpet into vehicle.
10. Install the front split bench seat.
11. Enable the SIR system. Refer to, SIR Disabling and Enabling Zone 8.
12. Program the new SDM into the dash integration module (DIM). Refer to Body Control Module (BCM) Programming/RPO Configuration.

IMPORTANT: The AIR BAG indicator may remain ON after the SDM has been replaced. DTC B1001 may set requiring the SDM part number to be set in multiple modules. If the indicator remains ON after enabling the SIR system, perform the diagnostic system check and follow the steps thoroughly to ensure that the SDM is set properly. Testing and Inspection