Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2006LUCERNE V6-3.8L VIN 2REPAIR AND DIAGNOSISMAINTENANCETIMING COMPONENT ALIGNMENT MARKSLOCATIONS
2006 Buick Lucerne V6-3.8L VIN 2
Timing Component Alignment Marks: Locations
2006 Buick Lucerne V6-3.8L VIN 2SECTION Locations
^ Align the timing marks on the balance shaft drive gear and the balance shaft driven gear.
^ Install the crankshaft sprocket.
^ Install the timing chain and sprocket.
^ Assemble the timing chain on the sprockets with the timing marks as close together as possible.
^ Important: Rotate the engine two revolutions and check the timing marks. Ensure that the marks are aligned.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.