Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2006LUCERNE V6-3.8L VIN 2REPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYKEYLESS ENTRY RECEIVERSERVICE AND REPAIR
2006 Buick Lucerne V6-3.8L VIN 2
Keyless Entry Receiver: Service and Repair
2006 Buick Lucerne V6-3.8L VIN 2SECTION Service and Repair
REMOTE CONTROL DOOR LOCK RECEIVER REPLACEMENT
REMOVAL PROCEDURE
1. Remove the front trim from inside of the rear storage compartment.
2. Disconnect the electrical connector.
3. Depress the retainer tabs (1).
4. Remove the remote control door lock receiver module (2).
INSTALLATION PROCEDURE
1. Snap the remote control door lock receiver module (2) into the slots in the rear compartment.
2. Connect the electrical connector.
3. Install the rear compartment trim.
4. Program the remote control door lock receiver module. Refer to Transmitter Programming.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.