Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Entering the Diagnostics Mode
1999 Buick LeSabre V6-3.8L VIN KSECTION Entering the Diagnostics Mode
In order to enter the body control module (MALL) diagnostic mode perform the following steps:
1. Place the ignition switch in the ON position.
2. Press and hold the power door unlock switch.
3. Within 20 seconds of pressing the unlock switch, cycle the headlamps 6 times.
4. Release the power door unlock switch.
1. Place the ignition switch in the ON position.
2. Press and hold the power door unlock switch.
3. Within 20 seconds of pressing the unlock switch, cycle the headlamps 6 times.
4. Release the power door unlock switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.