Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK1999LESABRE V6-3.8L VIN KREPAIR AND DIAGNOSISCRUISE CONTROLCRUISE CONTROL SWITCHSERVICE AND REPAIRCRUISE RELEASE SWITCH REPLACEMENT
1999 Buick LeSabre V6-3.8L VIN K
Cruise Release Switch Replacement
1999 Buick LeSabre V6-3.8L VIN KSECTION Cruise Release Switch Replacement
REMOVAL PROCEDURE
IMPORTANT: Connect the brake booster pushrod to the brake pedal assembly before attempting to adjust the release switch assembly (1) and the stoplamp switch assembly (2).
1. Remove the left insulator panel.
2. Disconnect the electrical connector.
3. Remove the release switch assembly (2).
INSTALLATION PROCEDURE
1. Install the release switch assembly (2).
2. Connect the electrical connector.
IMPORTANT: An incorrect adjustment may cause the cruise control system to work improperly.
3. Adjust the switch. Refer to Cruise Release Switch Adjustment. Cruise Release Switch Adjustment
4. Install the left insulator panel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.